Thingiverse
TI Tiva C LaunchPad Box
by Thingiverse
Last crawled date: 5 years, 4 months ago
Just a box for holding my TI dev board.
I like to have high walls protecting the pin headers.
Using M3 screws close to the edge of the board to keep it secure.
The tolerances are a bit tight (0.1mm clearance) since my printer is good, if yours isn't you might run into troubles. I don't expect this to be popular so I won't bother to do it any other way.
I like to have high walls protecting the pin headers.
Using M3 screws close to the edge of the board to keep it secure.
The tolerances are a bit tight (0.1mm clearance) since my printer is good, if yours isn't you might run into troubles. I don't expect this to be popular so I won't bother to do it any other way.