Thingiverse
Thinner Spool Hole Spool Holder by rgbextruder
by Thingiverse
Last crawled date: 4 years, 1 month ago
http://www.youtube.com/watch?v=oly6A4GSLD0
Thinner Spool Hole Spool Holder for CTC Replicator / Flashforge / Wanhao and others with a 30mm rear hole.
the factory holder was 30mm. too thick for most spools.
this one is only 20mm, so all spools should fit onto.
nuts are already prescaled to 104% to fit with pla.
ready-to-print.
prints without support and without raft from pla.
Thinner Spool Hole Spool Holder for CTC Replicator / Flashforge / Wanhao and others with a 30mm rear hole.
the factory holder was 30mm. too thick for most spools.
this one is only 20mm, so all spools should fit onto.
nuts are already prescaled to 104% to fit with pla.
ready-to-print.
prints without support and without raft from pla.