Cults
Thing 1 and Thing 2
by Cults
Last crawled date: 7 years, 9 months ago
"Would you like to shake hands
With Thing One and Thing Two?" -The Cat in the Hat
I noticed that Thingiverse didn't have a "Thing" in it... so...
My filament colors are a bit off. The colors should be red, white, and cyan/light blue.
A fine tip permanent marker seems to work for the labeling and, if you want, drawing in the face.
I've included built-in supports for the few parts that needed them.
In order to align the parts, I've left a slot that accepts 1.75mm filament. The slot is 2mm, but you may need to open it up using heat or a file. It can close up due to first layer flattening.
"And then he was gone
With a tip of his hat."
With Thing One and Thing Two?" -The Cat in the Hat
I noticed that Thingiverse didn't have a "Thing" in it... so...
My filament colors are a bit off. The colors should be red, white, and cyan/light blue.
A fine tip permanent marker seems to work for the labeling and, if you want, drawing in the face.
I've included built-in supports for the few parts that needed them.
In order to align the parts, I've left a slot that accepts 1.75mm filament. The slot is 2mm, but you may need to open it up using heat or a file. It can close up due to first layer flattening.
"And then he was gone
With a tip of his hat."