Thin Print Test by nothermonkey

Last crawled date: 3 years, 2 months ago

This is a test for flexibility. The intended use for flexible layers was for hinges.
They are 10cm x 10cm squares of thickness, 0.1mm, 0.2mm, 0.3mm, ..., 0.9mm, 1.0mm.
I keep on hand, for reference, the following ten sheets:
-0.1mm sheet @ 0.1mm layer height
-0.1mm sheet @ 0.2mm layer height
-0.2mm sheet @ 0.1mm layer height
-0.2mm sheet @ 0.2mm layer height
-0.2mm sheet @ 0.3mm layer height
--repeat till:
-0.4mm sheet @ 0.2mm layer height
Past 0.4mm thickness, the flexibility is likely only useful for springs.