Thingiverse
THE PADDLER by CNCereal
by Thingiverse
Last crawled date: 4 years ago
This is my submission to Maker's Muse's wacky wheels video! the concept was to use "scoop" like paddles to try to dig through the sand and keep traction. i want the wheel to be facing such that the flats of the triangles are biting into the ground rather than the points
I did my best to keep overhangs to no more than 45 degrees, but i may have made a difficult part to print. I'm a beginner with fusion 360, and wanted to see what i could do, but didn't sweat it too hard in terms of complicating or optimizing it. i wanted to make the treads more of a wire-frame look, but didn't have the knowledge to pull it off.
feel free to give suggestions or criticism in the comments!
maker's muse videos:https://www.youtube.com/watch?v=r9ZTWQtzk2Yhttps://www.youtube.com/watch?v=rSCKAbSVIMA
I did my best to keep overhangs to no more than 45 degrees, but i may have made a difficult part to print. I'm a beginner with fusion 360, and wanted to see what i could do, but didn't sweat it too hard in terms of complicating or optimizing it. i wanted to make the treads more of a wire-frame look, but didn't have the knowledge to pull it off.
feel free to give suggestions or criticism in the comments!
maker's muse videos:https://www.youtube.com/watch?v=r9ZTWQtzk2Yhttps://www.youtube.com/watch?v=rSCKAbSVIMA