Thingiverse
Tevo Tornado Standalone mod by roufster
by Thingiverse
Last crawled date: 4 years, 1 month ago
This standalone mod is for the Tevo Tornado MKS GEN L version. It does not need any extension cables, soldering or new hardware except for mounting screws.
I mounted the PSU and all the components on a 19x19cm acrylic board. I drilled holes on the bottom to hold the PSU and the MKS GEN L Holder in place. The four sides of the box snap onto the acrylic board. I superglued the front and back sides to the right side. This way, the left side which holds all the connections can be taken out to easily access the components. You can also access them from the top by sliding the bed all the way to the front.
The sides of the box are labeled as: Box (Left, Right, Front, Back) Side. There is also a top cover after it is mounted. I used a 6x12cm and 10x10cm acrylic sheets for the front and top openings.
For the Board, you need 2 MKS GEN L Holder, MKS GEN L fan holder and MKS GEN L fans cover. The purpose of printing 2 parts of the holder is to:
1- Align with the USB port slot on the front
2- Gives you a separator to pass all the cables from the SSR to the front under the board neatly and without interference.
The fans holder is for 2 5010mm fans.
The SSR is mounted using the same screws on the grills on the right side. I just added two big washers to hold it in place.
For the display, you need a Display Front, Back, Holder and Knob. It mounts directly under the y-belt tensioner on the front of the printer.
I remixed and used files from these mods below:
https://www.thingiverse.com/thing:2805000/https://www.thingiverse.com/thing:2868695/
Feet can be found here:
https://www.thingiverse.com/thing:2993206
I mounted the PSU and all the components on a 19x19cm acrylic board. I drilled holes on the bottom to hold the PSU and the MKS GEN L Holder in place. The four sides of the box snap onto the acrylic board. I superglued the front and back sides to the right side. This way, the left side which holds all the connections can be taken out to easily access the components. You can also access them from the top by sliding the bed all the way to the front.
The sides of the box are labeled as: Box (Left, Right, Front, Back) Side. There is also a top cover after it is mounted. I used a 6x12cm and 10x10cm acrylic sheets for the front and top openings.
For the Board, you need 2 MKS GEN L Holder, MKS GEN L fan holder and MKS GEN L fans cover. The purpose of printing 2 parts of the holder is to:
1- Align with the USB port slot on the front
2- Gives you a separator to pass all the cables from the SSR to the front under the board neatly and without interference.
The fans holder is for 2 5010mm fans.
The SSR is mounted using the same screws on the grills on the right side. I just added two big washers to hold it in place.
For the display, you need a Display Front, Back, Holder and Knob. It mounts directly under the y-belt tensioner on the front of the printer.
I remixed and used files from these mods below:
https://www.thingiverse.com/thing:2805000/https://www.thingiverse.com/thing:2868695/
Feet can be found here:
https://www.thingiverse.com/thing:2993206