Thingiverse
Tevo Tarantula Noctua Fan Duct by BusterBeagle3D
by Thingiverse
Last crawled date: 4 years, 7 months ago
*****UPDATE: Improved the design and remixed this. Still uses the same fans but the xcarraige, fan duct, and connection are all new including a wire cover. You can find it here: https://www.thingiverse.com/thing:3139515
This is my Tevo Fan Duct made for use with Noctua fans. I wanted to make my printer as silent as possible so this is my setup. This is the first model I uploaded so I hope everything loads correctly.
The Fan shroud is of my design and allows for the usage of 2 Noctua 40x40x20, and one 40x40x10 for the heat sink.
The x carriage is a large remix of two different makes:
rc_mrk's Tevo Tarantula X-Carriage with Fan and Belt Tensionerhttps://www.thingiverse.com/thing:1938505
and fits thingirob's Tevo Tarantula Modular X Car Basichttps://www.thingiverse.com/thing:1438795
I have used this design for some time now and it works great.
Parts list:
2 Noctua NF-A4x20 FLX (self driving screws from set used to mount)
1 Noctua NF-A4x10 FLX
1 40mm M4 Bolt with Nut (For belt tensioner)
2 M4x15 for Heatsink fan mount to shroud (mount last)
2 M3 screws from original heatsink fan to mount lower part of Fan shroud
2 M4x9 with nuts to mount Shroud to modular xcarriage connection.
1 Rubber Band (I'm using it as a seal that I added around the base of the top 2 fans, see pictures)
One last thing....
You may notice a vertical hole on the back of the modular connection. I use that along with a m3 screw to level the hotend. You may not need it but it's there if you do.
Hope you like it!
This is my Tevo Fan Duct made for use with Noctua fans. I wanted to make my printer as silent as possible so this is my setup. This is the first model I uploaded so I hope everything loads correctly.
The Fan shroud is of my design and allows for the usage of 2 Noctua 40x40x20, and one 40x40x10 for the heat sink.
The x carriage is a large remix of two different makes:
rc_mrk's Tevo Tarantula X-Carriage with Fan and Belt Tensionerhttps://www.thingiverse.com/thing:1938505
and fits thingirob's Tevo Tarantula Modular X Car Basichttps://www.thingiverse.com/thing:1438795
I have used this design for some time now and it works great.
Parts list:
2 Noctua NF-A4x20 FLX (self driving screws from set used to mount)
1 Noctua NF-A4x10 FLX
1 40mm M4 Bolt with Nut (For belt tensioner)
2 M4x15 for Heatsink fan mount to shroud (mount last)
2 M3 screws from original heatsink fan to mount lower part of Fan shroud
2 M4x9 with nuts to mount Shroud to modular xcarriage connection.
1 Rubber Band (I'm using it as a seal that I added around the base of the top 2 fans, see pictures)
One last thing....
You may notice a vertical hole on the back of the modular connection. I use that along with a m3 screw to level the hotend. You may not need it but it's there if you do.
Hope you like it!