Tevo Tarantula MKS Board Cable Strain Relief by Sardinator

Last crawled date: 3 years, 1 month ago

After seeing the strain relief model made by Charles_Snyder (https://www.thingiverse.com/thing:2451150) I printed one, but It was quite big, needed supports and I couldnt fit the top plate with the fan back on, so I made my own version.
Advantages for this model:
minimalistic design
no support needed
less plastic needed for the print
good clearance from the solder on the back of the mks board
allows the top plate with the fan to be mounted
cca 20 min print
-> IMPORTANT:
when you fit this model to your board, you are going to have to add a M3 nut between the brass spacer an the board to level the board on the other (top) side.
instead of M3x20 screws, I used M3x25 because:
1) I use washers everywhere;
2) the M3 nut goes barely half way on the M3x20 screw with all things added
If you are using the MKS board offset like I do, you will need to replace the bottom left M3x25 screw with M3X20 screw so it doesnt touch the offset
I made this in AutoCAD so dwg file is included if anyone wants to make his own model.