Thingiverse
TEVO TARANTULA LOW PROFILE CASE OFFSET by dysan45
by Thingiverse
Last crawled date: 4 years, 5 months ago
Wanted to remix original offset support for the tarantula control case by tulsaturbo.
Smaller profile.
Built-in filament guide keeps the filament from straying .
Option of double built-in t-nut or single built-in plus real t-nut to lock.
M4 nuts allow easy fastening to control case acrylic.
T-nut shape and size for good fit.
You may use both of the same type or one of each.
I had no trouble sliding these in or out but this may vary depending on your printer calibration. Eg: If your first layer is prints wide and needs trimming.
M4 nuts required where necessary and just reuse the original M4 bolts and a t-nut.
Smaller profile.
Built-in filament guide keeps the filament from straying .
Option of double built-in t-nut or single built-in plus real t-nut to lock.
M4 nuts allow easy fastening to control case acrylic.
T-nut shape and size for good fit.
You may use both of the same type or one of each.
I had no trouble sliding these in or out but this may vary depending on your printer calibration. Eg: If your first layer is prints wide and needs trimming.
M4 nuts required where necessary and just reuse the original M4 bolts and a t-nut.