Thingiverse
test square
by Thingiverse
Last crawled date: 6 years, 4 months ago
its not a freaking benchie!
This is to test the scale and squareness of your printer.
print, do NOT remove from bed!
measure from the same edge (left and top) of opposte sides, doing this removes the width of the print nozzel as an error factor. the distance should be 100mm
measure the cross corner distance, it should be the same (whatever it is)
scale and skew as req'd.
This is to test the scale and squareness of your printer.
print, do NOT remove from bed!
measure from the same edge (left and top) of opposte sides, doing this removes the width of the print nozzel as an error factor. the distance should be 100mm
measure the cross corner distance, it should be the same (whatever it is)
scale and skew as req'd.