Thingiverse
Tesla Model 3 Trunk spring cover
by Thingiverse
Last crawled date: 5 years, 5 months ago
This is a cover to mask the trunk spring when you install an automatic trunk lifter on your Tesla Model 3.
The cover is in two pieces, the cover placed at the bottom and the shoulder washer placed at the top.
You must align the water evacuation hole at the bottom after installation.
To print the shoulder washer is very easy, i advise you to print it in ABS at 100% infill and 0.25mm layer, 0.4mm nozzle.
To print the cover, I advise you to print the firsts 3mm at 100% infill, 0.25mm layer, 0.4mm nozzle and print the lasts mm in vase mode with a 0.5mm wall width, 0.25mm, 0.4mm nozzle layer for a better quality.
The cover is in two pieces, the cover placed at the bottom and the shoulder washer placed at the top.
You must align the water evacuation hole at the bottom after installation.
To print the shoulder washer is very easy, i advise you to print it in ABS at 100% infill and 0.25mm layer, 0.4mm nozzle.
To print the cover, I advise you to print the firsts 3mm at 100% infill, 0.25mm layer, 0.4mm nozzle and print the lasts mm in vase mode with a 0.5mm wall width, 0.25mm, 0.4mm nozzle layer for a better quality.