Thingiverse

Temperature Knob for Weller Soldering Station by GeorgeH
by Thingiverse
Last crawled date: 4 years, 1 month ago
This is a replacement knob for the Weller WES51 Analog Soldering Station. I designed this part after being given a WES51 with a broken knob.
Drill the hole out with a #21 drill, and add a 10-32 bolt. Grind the sides down, and it will fit perfectly into your WES51's temperature control potentiometer.
WARNING: I have verified that the base of this part will print, but have not yet tested it on my soldering station. There is a good chance the rectangular shaft is too thick, as I would like it to press-fit into the potentiometer on the soldering station.
NOTE: SLDPRT is SolidWorks 2011 format.
Drill the hole out with a #21 drill, and add a 10-32 bolt. Grind the sides down, and it will fit perfectly into your WES51's temperature control potentiometer.
WARNING: I have verified that the base of this part will print, but have not yet tested it on my soldering station. There is a good chance the rectangular shaft is too thick, as I would like it to press-fit into the potentiometer on the soldering station.
NOTE: SLDPRT is SolidWorks 2011 format.