Thingiverse
Temp Tower for Makerbot Clones by mikejsmith1985
by Thingiverse
Last crawled date: 4 years, 2 months ago
Originally put together by thingiverse user @inventimark
I used multiple profiles in S3D for both extruders to create the g-code attached.
Print Speed is 80mms
Layer Height is .2mm
Cooling fans are 0 at layer 1 and 100% from then on
Temperature changes every 6mm and of course reflects the number identified in the block
My specific unit is a PowerSpec Ultra but I believe this g-code should work for any Flashforge or similar clone.
I used multiple profiles in S3D for both extruders to create the g-code attached.
Print Speed is 80mms
Layer Height is .2mm
Cooling fans are 0 at layer 1 and 100% from then on
Temperature changes every 6mm and of course reflects the number identified in the block
My specific unit is a PowerSpec Ultra but I believe this g-code should work for any Flashforge or similar clone.