Telrad Holder for AR102 by redbaron12

Last crawled date: 3 years, 1 month ago

I stumbled across the original file and thought what a great idea. I have an AR102 and there really isn't a lot of room to mount a Telrad so this solves the problem. I made three modifications to the original file to allow me to install it and remove it without having to take the rings off. Of course you could take that little safety screw out but then I'd probably loose it so I added a channel that allows you to slide it in from the back, over the little screw and I added a block to the screw side channel of the finderfoot to prevent it from sliding out if the screw loosens up. Finally, I raised it up 8mm to avoid interference with the rings. However, depending on how your scope is mounted, you may need to rotate it slightly to avoid the tightening down screw of the back ring.
The fit was snug on my printer without any adjustments and required a little filing to allow the telrad to seat squarely on the bottom of the cradle. Even without the screw, it isn't moving.
The original file can be found here:https://www.thingiverse.com/thing:3004769