Thingiverse

Telight candle holder (concrete mold) by Jakwit
by Thingiverse
Last crawled date: 4 years, 5 months ago
You need to print 4 of the model called corner, and 1 og the model called center.
I used electrical tape to hold the mold together while using the mold.
TIP: The outer mold is easy to remove after casting, but the "centerplugg" can be a struggle. A trick is to put a small ballon around it. And also, use some oil or silicone spray on the mold before adding castingmaterial.
I used electrical tape to hold the mold together while using the mold.
TIP: The outer mold is easy to remove after casting, but the "centerplugg" can be a struggle. A trick is to put a small ballon around it. And also, use some oil or silicone spray on the mold before adding castingmaterial.