Similar models
thingiverse
free
Nexstar 4 GT Bahtinov Filter by dlemmink
...your celestron nexstar 4gt telescope.
just align the filter vertically and slide the filter over the end of the telescope to use.
thingiverse
free
Telescope Solar Filter Ring 50mm by jensdeklerk
...telescope solar filter ring 50mm by jensdeklerk
thingiverse
telescope solar filter ring 50mm
thingiverse
free
Solar filter telescope mount (customizable) by sebastiansw
... film nd 5.0.
warning. never view the sun without a solar filter! solar observing is dangerous and can be hazardous to eyesight.
thingiverse
free
Telescope adapter for Lee Filter Ring by noisejammer
...pter to connect a lee fp105 ring to a refractor telescope. primary use will be polarimetry of the solar corona during an eclipse.
thingiverse
free
Solar Filter for use with filter foil by calli
...ey are still fitted to the telescope. remember: looking trough a telescope into the sun without proper filter can make you blind!
thingiverse
free
ETX-90 Solar Filter Ring
...u using this design. looking at the sun directly or through a telescope can cause permanent damage to the retina and blind spots.
thingiverse
free
Telescope Pin Hole Sun Finder by SandmanMike
...to the center of the target.
***always use an appropriate sun filter on your telescope, and don't look directly at the sun!
thingiverse
free
Adapter Telescope T2 2" Nikon by Elmirok
...adapter telescope t2 2" nikon by elmirok
thingiverse
adapter telescope t2 2" nikon with filter thread.
thingiverse
free
114mm Telescope Filter Holder by risenrigel
...are used for the 6x30 spotting scope and red dot spotting scope. also works on a newer meade ds2114, 114mm/4.5" goto scope.
thingiverse
free
Parametric solar filter for a telescope by pulsar123
...op part (the silver side has to face the sun!), then attached it to the bottom part with eight m3x6mm bolts and matching m3 nuts.
Microstrat
thingiverse
free
Dali's Clock by microstrat
...aba
inspired by slavador dali's "the persistence of memory" https://en.wikipedia.org/wiki/the_persistence_of_memory
thingiverse
free
Rummikub replacement legs by microstrat
...this is a very simple replacement that will hopefully last longer.
by the way, it took much longer to print it than to design it.
thingiverse
free
Giant Enter button by microstrat
...ton.
use an arcade button as the trigger.
easy soldering even for my kids.
it's useless but fun.
https://youtu.be/b1xswmnwfos
thingiverse
free
Simple mini guitar model by microstrat
...t a little smaller than 16cm.
only four parts to print and few drops of glue.
could be a simple assembly projects for young kids.
thingiverse
free
uArcade - a Tiny arcade cabinet by microstrat
...ace invaders.
based on an arduino pro mini, a tiny oled and a rotary encoder as a joystick. (<$10)https://youtu.be/o1k2gcqksss
thingiverse
free
2080 Spool Holder by microstrat
...kjet printer?) to hang them all.
tip: print a 3rd thinner holder, and place it in the middle.
it'd be easier to replace rolls
thingiverse
free
Stickey - A Drumsticks keychain by microstrat
...#39;s easier to pull out (or snap in)
please share it with your drummer friends (the brainless apes at the back of the stage :) )
thingiverse
free
Bionic Hipster Glasses by microstrat
...pport needed!
printed on printrbot simple 10cm^3 (~4'') using pla. layer height = 0.35mm
https://youtu.be/rc3_y2ulqr4
thingiverse
free
MXR ISO Brick pedalboard mount by microstrat
... up, it's optional. having double sided tape is enough to hold.
important: print one side normal, the other mirrored(flipped)
Telescope
thingiverse
free
Telescope by hcarroll
...telescope by hcarroll
thingiverse
a small, old-fashioned telescope for your desk! the telescope is collapsible
thingiverse
free
telescope by Sedekus
...telescope by sedekus
thingiverse
toy telescope
thingiverse
free
Telescope teleskop
...telescope teleskop
thingiverse
telescope design for the wall
thingiverse
free
Telescope by lizard657
...telescope by lizard657
thingiverse
3d printed telescope built on top of a cardboard tube.
thingiverse
free
Telescope by SeveQ
...up was used to gift him a small fraction of the needed money (you can screw off the front cap and put something in the telescope)
thingiverse
free
Telescoping Staff by ghost_coffee
...telescoping staff by ghost_coffee
thingiverse
customizable telescoping staff!
thingiverse
free
support for telescope by Fablab3lapins
...support for telescope by fablab3lapins
thingiverse
an support for telescope (laser pointer)
thingiverse
free
telescope yoke by Niedzwiedz
...telescope yoke by niedzwiedz
thingiverse
this is the part of rotating yoke of telescope.
thingiverse
free
Telescoping Stick by Person21
...stick by person21 thingiverse it is a stick that telescope when...
thingiverse
free
Telescoping Stick by Person21
...stick by person21 thingiverse it is a stick that telescope when...
Filter
thingiverse
free
Filter adapters for Filter Caddy
...sting/735698930/filter-caddy-a-storage-case-for-camera)
currently there is a 52mm filter adapter, but others will be coming soon.
thingiverse
free
filter by AMSSTEM79
...filter by amsstem79
thingiverse
a filter
thingiverse
free
Aquarium Pre filter for external filters
...re filter for external filters to minimize cleaning. uses a basic green scratchy or brillow pad for filtration. works awesome!!
thingiverse
free
3M filter
...3m filter
thingiverse
3m filter
thingiverse
free
A sink filter
...a sink filter
thingiverse
a sink filter.
thingiverse
free
filter by bingles1
...filter by bingles1
thingiverse
filter, pla
thingiverse
free
filter by mming1106
...filter by mming1106
thingiverse
my 3dp filter
thingiverse
free
Filter by mkproduction
...filter by mkproduction
thingiverse
filament filter - vertex k8400
thingiverse
free
EOS clip filter using 1.25inch filter by soiyadakara
...eos clip filter using 1.25inch filter by soiyadakara
thingiverse
this converts 1.25inch filter to eos clip filter.
thingiverse
free
Filter Mask for ZWO 31mm Filters
...ngiverse
mask for zwo 31mm filters. this is my tweak of mikefulb's design at https://github.com/mikefulb/zwo31mmfiltermask,
Adapter
thingiverse
free
Adapter
...adapter
thingiverse
adapter to use filament rolls with 72mm inside diameter
thingiverse
free
adapter by Ladehoff
...adapter by ladehoff
thingiverse
adapter
thingiverse
free
adapter by eslyuta
...adapter by eslyuta
thingiverse
adapter
thingiverse
free
Clean 45RPM adapter, single adapter
...clean 45rpm adapter, single adapter
thingiverse
clean, basic 45rpm adapter. fits most turntables.
thingiverse
free
Fan Adapter
...fan adapter
thingiverse
fan adapter
thingiverse
free
Lens adapter
...lens adapter
thingiverse
lens adapter
thingiverse
free
Fahrradventiel Adapter
...fahrradventiel adapter
thingiverse
fahrradventiel adapter
thingiverse
free
adapter with by dougthegr8
...adapter with by dougthegr8
thingiverse
adapter holder
thingiverse
free
gopro adapter
...gopro adapter
thingiverse
angal adapter for gopro
thingiverse
free
Socket Adapter
...socket adapter
thingiverse
hand twist socket adapter