Thingiverse
Technics SL-D2 turntable foot by dofasol
by Thingiverse
Last crawled date: 4 years ago
This is a modeling file to replace any technics SL-D2 lost foot.
May apply to other technics turntable with similar spring and rubber feet.
This is my 1st contribution, i hope i didn't completely messed up
This is a Black ABS 100 micron 3D print.16,26 cm3 . Printing time 2 hours 18 minutes.
On the pictures with two feet you can see the printed model (left) and the original model (right)
Note that for printing facilities the base is flat.
at the end it fits perfectly the rubber foot and the turntable is now laying on it's 4 feet again!
May apply to other technics turntable with similar spring and rubber feet.
This is my 1st contribution, i hope i didn't completely messed up
This is a Black ABS 100 micron 3D print.16,26 cm3 . Printing time 2 hours 18 minutes.
On the pictures with two feet you can see the printed model (left) and the original model (right)
Note that for printing facilities the base is flat.
at the end it fits perfectly the rubber foot and the turntable is now laying on it's 4 feet again!