Team Corally Steering Bellcrank by rivado

Last crawled date: 3 years, 2 months ago

This part broke after the car hit against an obstacle. Disgned this quick'n'dirty and will use it until the next order. The original spare parts costs just a few bucks. Replaces one part in this set: C-00180-036
I removed the stairs effect from the 0.2 layers with sand paper. Maybe it's a good idea to try 0.1 layer next time.
UPDATE:
One hard crash later, I had print another one in 0.1 and I definitely recommend this. Took me at 60 mm/s around 75 minutes to print.
UPDATE 2:
After another crash, I reinforced it ab bit and printed in ABS.
UPDATE 3:
Pritning in ABS did not make any difference, it brakes at the same spot. So created Version 2 to be more robust and back to PLA.
UPDATE 4:
If Version 2 does not fit in your steering setup, try Version 3. :D