Thingiverse
Tea Infuser Lid by FroggyExact
by Thingiverse
Last crawled date: 4 years, 10 months ago
The original tea pot did only come with the infuser.
So I set out to design a lid that:
fitted as snug as possible
stays put when pouring tea
keeps vapor/condens in
is water/vapor tight
withstands 100 degrees Celsius
That last one was solved accidentally: I set up a new spool from the dry-box without checking the label..I never saw PETG warp so incredibly...it appeared to be PolyCarbonate...duh
The other demands were met after a few trials.
The knob and lid are printed separately and should fit snugly.
Screw/unscrew a few times to remove any burrs or oozing artifacts.
So I set out to design a lid that:
fitted as snug as possible
stays put when pouring tea
keeps vapor/condens in
is water/vapor tight
withstands 100 degrees Celsius
That last one was solved accidentally: I set up a new spool from the dry-box without checking the label..I never saw PETG warp so incredibly...it appeared to be PolyCarbonate...duh
The other demands were met after a few trials.
The knob and lid are printed separately and should fit snugly.
Screw/unscrew a few times to remove any burrs or oozing artifacts.