Thingiverse
TBS Event Tracker 3/4" PVC Mount by zanthor
by Thingiverse
Last crawled date: 4 years, 3 months ago
Slapping your TBS Event Tracker on the ground creates undesirable reception and makes tracking LESS accurate than having the Event Tracker elevated. I designed this mount to sit on a 3/4" pvc pipe which I put behind a gate.
Designed to be printed out of TPU - I imagine this could work out of a rigid filimant, but then you'd have to slide it over the end of the PVC instead of being able to slip it over the pipe in the middle.
The Event Tracker sits behind the top panel of the gate protecting it from direct hits, and the mount allows it to move if hit to help dissipate energy and not break anything. I also mount the ET with the USB ports and network jacks facing away from oncoming traffic so if it does get hit the case of the ET is taking the brunt of the force, not electronics.
The top platform can be used to strap a lipo to, or POE boxes as shown.
Designed to be printed out of TPU - I imagine this could work out of a rigid filimant, but then you'd have to slide it over the end of the PVC instead of being able to slip it over the pipe in the middle.
The Event Tracker sits behind the top panel of the gate protecting it from direct hits, and the mount allows it to move if hit to help dissipate energy and not break anything. I also mount the ET with the USB ports and network jacks facing away from oncoming traffic so if it does get hit the case of the ET is taking the brunt of the force, not electronics.
The top platform can be used to strap a lipo to, or POE boxes as shown.