Tape Ball by Guiseppi

...is a multi tool that has a sharper edge for removal and instalation, and a hooked side for hard to remove tape to be scraped out.

... is supposed to go in conjunction with the pencil holder pin and pin stand located here: http://www.thingiverse.com/thing:1965445

...his tray to hold 5 pingpong balls. attached it to the underside of table with command strips (could use double-sided foam tape).

...itting around. i'm planning another design utilizing a round measuring tape that can be more tightly integrated with the cup.

...golf_ball thingiverse anti vibration foot for anycubic predator. insert a golf ball. i stick it with a piece of double face tape

...the fork legs. this gives the mechanism more holding power. it will work without the band, but it is definitely improved with it.

..., passing the wire through the center of the ball/socket joints. still a work in progress, the code is incredibly messy right now

...ount. i used these to mount fish-eye camera to walls. i use 3m 200mp double-sided tape to attach faceplate to camera's back.

... other junk out of an icon aftermarket upper control arm ball joint after printing, the part is attached with double stick tape.

...hingiverse prints separately and then snaps together. i used mounting tape to stick it to the wall and attach the sensor to it.

...ww.thingiverse.com/syzguru11/collections/balls (donations appreciated, but not necessary. my things are free and will always be).

...ball in ball by patricksalvador thingiverse ball in ball

...in a ball by simon_vance thingiverse i just put together a random thing because i was bored and it was just a 20 minute project.

...ball in a ball by zakw thingiverse ball within a ball

... by devinwilcox thingiverse break ball loose and enjoy! big thanks to gkewley for the picture of the white printed ball in ball.

...lls. 2015 | printed the ball in ball in ball with my mendel 90 with support sliced with slic3r and it is working fine. 50% size

...://www.thingiverse.com/thing:2754149 also check out my oyher ball designshttps://www.thingiverse.com/syzguru11/collections/balls

...l bearing by quanrbit thingiverse this remix is designed for single balls in ball bearings 7.3mm/0.287" diameter using brim

...twisted ball in ball in ba.... by syzguru11 thingiverse twisted ball in ball in ba....

...twisted ball in ball in ba.... by syzguru11 thingiverse twisted ball in ball in ba....

...tape holder thingiverse just a tape holder for tape

...tape holder thingiverse tape holder or tape dispenser

...duct tape (duck tape) by legged_fiash thingiverse duct tape wooooooo

...er for 50mm tape here you'll find the drawing on tinkercad:https://www.tinkercad.com/things/6w6jfp9ljz5-50mm-tape-dispenser

...e holder by omermoshai thingiverse this is a tape holdet to put near your 3d printer so you can replace the painters tape easely

...tape holder thingiverse tape holder

...tape / gaff tape holder by dlemmink thingiverse tape holder for duct or gaff tape with mounting hole for flathead bolt or screw.

...la, 3d printer: prusa i3 mk3. after you print, you'll need a razor blade at the end of the holder, so you can piece the tape.

...spenser by jesse thingiverse super-sized version of the mini tape gun. this version fits a regular 3 inch roll of packing tape.

...tape pedestal thingiverse tape pedestal, for exhibition. (the glass urn is from ikea)