Thingiverse
Tap Wrench by Exitoo
by Thingiverse
Last crawled date: 4 years, 7 months ago
Because I was bored today, I have constructed a tap wrench.
The individual parts should be printable. I have not tried it yet but I will print soon.
To hold the little Hammer on the Screw just take 2 pice 2mm Pass pin´s.
Have fun with it :D
08.04.2017: Update. Edited Part 2 with 2 Pass pin´s.
The individual parts should be printable. I have not tried it yet but I will print soon.
To hold the little Hammer on the Screw just take 2 pice 2mm Pass pin´s.
Have fun with it :D
08.04.2017: Update. Edited Part 2 with 2 Pass pin´s.