Thingiverse
Tamiya TT-02 RWD Drift Steering Angle Mod by Otowngman
by Thingiverse
Last crawled date: 4 years, 2 months ago
Tamiya TT-02 RWD Drift Steering Angle Mod
Introduction
Want to drift your Tamiya TT-02 but don't want to pay a crazy amount for a drift conversion kit? Look no further. This replaces the stock steering arms for arms that will give much more angle than stock. I don't think this will work with the front driveshafts still installed.
Instructions:
Remove the front driveshafts
Cut the steering stops from the front hubs and the upper/lower control arms
Press in the ball sockets into the steering rods (much like you did when building the kit)
NOTE: Ideally you would use turnbuckles, however, for the sake of a fully 3D printed mod the included rods will work
Install the new steering arms using the stock hardware
Ensure your steering endpoints are set in your transmitter to avoid overstressing the parts
Enjoy your new drifting experience!
Introduction
Want to drift your Tamiya TT-02 but don't want to pay a crazy amount for a drift conversion kit? Look no further. This replaces the stock steering arms for arms that will give much more angle than stock. I don't think this will work with the front driveshafts still installed.
Instructions:
Remove the front driveshafts
Cut the steering stops from the front hubs and the upper/lower control arms
Press in the ball sockets into the steering rods (much like you did when building the kit)
NOTE: Ideally you would use turnbuckles, however, for the sake of a fully 3D printed mod the included rods will work
Install the new steering arms using the stock hardware
Ensure your steering endpoints are set in your transmitter to avoid overstressing the parts
Enjoy your new drifting experience!