Tail for Arduino by aevictory

Last crawled date: 4 years, 7 months ago

A wagging tail.
Print the tail top and tail bottom.
Rubber cement one side to a flexible material, I used a shelf liner. Leave space between parts
Cut out the material
Rubber cement the other side lining up carefully
Sew the edge holes
I used a 3-doodler to reinforce some of the top holes
Thread fishing line with high test through the top holes of both sides and secure at the end of the tail
Thread the fishing line through the motor mount and the servo wheel.
Secure the thread to the servo wheel with laces of fishing line
Use the arduino file to wag the tail
V2 uses less plastic and has reinforcement over the top holes