Thingiverse
Taig 5019CR mill stock column home sensor mount
by Thingiverse
Last crawled date: 5 years, 9 months ago
This is home sensor mount for Taig Mill with stock column.
The proximity switch I used is Aotoro TS18-5DN (12-24VDC, NPN, Normal Closed).
I've my X table reversed, that's why the stepper motor is at the left-hand side.
For Z-axis You might want to use longer screw (10-32 UNF) so you can use hex nut to secure the mount from the back.
Update:
20191019: For Y-axis, put sensor up-side-down will help to avoid chip guard get caught between sensor and carriage. Photo updated (no change on model)
The proximity switch I used is Aotoro TS18-5DN (12-24VDC, NPN, Normal Closed).
I've my X table reversed, that's why the stepper motor is at the left-hand side.
For Z-axis You might want to use longer screw (10-32 UNF) so you can use hex nut to secure the mount from the back.
Update:
20191019: For Y-axis, put sensor up-side-down will help to avoid chip guard get caught between sensor and carriage. Photo updated (no change on model)