Thingiverse
Tacoma Gen 2 Mirror Extension
by Thingiverse
Last crawled date: 5 years, 9 months ago
I have not yet tested this but modelled it off of a working part.
purpose: raises the rearview mirror in the Gen 2 tacoma to be closer to the headliner. This is meant to improve the field of view in front of the vehicle.
I have not yet installed this myself but it involves removing the factory rearview and installing this adapter in between the windshield and mirror bracket. Be very careful not to break you windshield by over tightening the mounting fasteners.
I would print this at a 0.2mm with support, unless your bridge settings are good in which case supports may not be needed. As I have not played around with fitment/tolerances yet on this part it may need to be reprinted at 1-4% over/undersized scale in slicer.
purpose: raises the rearview mirror in the Gen 2 tacoma to be closer to the headliner. This is meant to improve the field of view in front of the vehicle.
I have not yet installed this myself but it involves removing the factory rearview and installing this adapter in between the windshield and mirror bracket. Be very careful not to break you windshield by over tightening the mounting fasteners.
I would print this at a 0.2mm with support, unless your bridge settings are good in which case supports may not be needed. As I have not played around with fitment/tolerances yet on this part it may need to be reprinted at 1-4% over/undersized scale in slicer.