Swivel Thing

...swivel eye - print in place by tikiluke thingiverse a simple print in place swivel eye. would probably be toughest in nylon.

...ivel eye 3 screw version - print in place by tikiluke thingiverse 3-screw swivel eye. should print in place without any trouble.

...bearing swivel by ronthomp thingiverse 3d printed swivel. 608 skate bearing. 8mm holes. the stl file prints both pieces at once.

...or wind sock. diameter of hole 12mm . best way to keep swivel strong is printing it with 45 degree angle as shown on the picutre.

...t swivel hanger with built-in support for the swivel. i needed to design this to have a better way to hang my headphones at work.

...swivel trapper. attach the swivel trapper with a short wood screw. the lower swivel goes between the 2 remaining swivel trappers.

...arm swivel a symm". this set replaces the last arm extender b. recommend to print with 2mm tom/bottom thickness, 20% infill.

...printed and looks fine. pla pref . abs might react to creace. pla temp: 200c bed : 50 c 2000mm/min 0,2mm layer height 100% infill

...ivel bracket used to attach flag to pole. exterior dimensions are 40mm x 47.5mm x 3mm. inner diameter is 30mm. printed with abs.

... pet. tolerances were adjusted for a tight fit on my setup, i'm not sure how it will translate to other printers / plastics.

...or wind sock. diameter of hole 12mm . best way to keep swivel strong is printing it with 45 degree angle as shown on the picutre.

...swivel holder by birdshotbrad thingiverse this is a 3/8 and 1/2 swivel holder.

...swivel mount. by steandron thingiverse swivel mount. excellent compound movable parts.

...swivel thing by shunt_voyager_net thingiverse a snake, a finger, a swivel thing. who knows.

...swivel vice by dazvette thingiverse gil humburg swivel vice surface grinder project

...swivel joint by rob311 thingiverse i figured i would try to make a swivel joint.

...pivot/swivel by littlegroundhog thingiverse pivot/swivel for rocket project ba1 vidéo : https://youtu.be/ator41geyna

...lcritchelow2018 thingiverse this peice is for a swivel base for use on the beach or camping. use plenty of infill for strength.

...swivel foot m6 by dyson72 thingiverse swivel foot m6 gelenkfuß m6

...thing thingiverse test

...thing thingiverse ohohohohhhooooohohohohoh

...thing by beastmode11114 thingiverse its a thing for a thing

...thing by lagsome thingiverse this is a thing

...thing by jgonzalez12 thingiverse thing

...thing by callsaul thingiverse thing

...thing by callsaul thingiverse thing

...thing by callsaul thingiverse thing

...thing by callsaul thingiverse thing

...thing by callsaul thingiverse thing