Thingiverse
Switch covers for the 1986 fj60 dash board by joorgawt
by Thingiverse
Last crawled date: 4 years, 5 months ago
These are switch covers for the switch holes in the dashboard.
You may need to scale +- a few percent depending on your printer settings. They should be snug and not wiggle when installed. Use a heat resistant filament.
If you use these, please give feedback on the fit and what filament you used.
I don't know what the big holes cover was supposed to look like so i mirrored the smaller hole ones where i had an example to go from.
If someone has a large switch hole cover please post pictures and dimensions.
You may need to scale +- a few percent depending on your printer settings. They should be snug and not wiggle when installed. Use a heat resistant filament.
If you use these, please give feedback on the fit and what filament you used.
I don't know what the big holes cover was supposed to look like so i mirrored the smaller hole ones where i had an example to go from.
If someone has a large switch hole cover please post pictures and dimensions.