Thingiverse
submarine project computer UDOO casing by Lanctot
by Thingiverse
Last crawled date: 4 years, 1 month ago
This is for the http://rovjacobsnotes.blogspot.com project. I made this to hold the UDOO or Arduino microcontrollers. If you make it with ABS you can use acetone to glue different mounts for sensors.
This will make an air pocket just in case stuff happens. The bottom is open, this should be ok, because this will still be an dry air pocket.
There are three screw holes to screw the mesh to the casing. and the casing is held to "the test pressure hall "by 44mm Small Size Clips.
added 17-Feb-2015:
More designs have been uploaded. (1) The computer support (Screw hole radius is 1.4mm ). (2) The power Shield(just as a precaution not to accidentally reset).
If the plastic of choice is ABS you can use acetone to weld the plastic together. To my knowledge acetone is fairly safe; it's the active ingredient nail polish remover.
This will make an air pocket just in case stuff happens. The bottom is open, this should be ok, because this will still be an dry air pocket.
There are three screw holes to screw the mesh to the casing. and the casing is held to "the test pressure hall "by 44mm Small Size Clips.
added 17-Feb-2015:
More designs have been uploaded. (1) The computer support (Screw hole radius is 1.4mm ). (2) The power Shield(just as a precaution not to accidentally reset).
If the plastic of choice is ABS you can use acetone to weld the plastic together. To my knowledge acetone is fairly safe; it's the active ingredient nail polish remover.