Thingiverse
Stratux ADS-B Raspberry Pi case. (Dual RTL-SDR/AHRS ) by helno
by Thingiverse
Last crawled date: 4 years, 5 months ago
edit: Unless you are using really old mini sized SDR's do not use this design
I highly recommend anyone who is not limited to a 6" print bed to make the long version of this case. http://www.thingiverse.com/thing:1016829 It works much better with SMA antennas as the MCX-SMA pigtails are attached to the case.
Three part case for the Open source Stratux ADS-B receiver for people with small 3d printers.
Supports dual RTL-SDR receivers. Remove the cases and use a small amount of hot glue to secure them to the middle layer. (Nov 6 increase thickness of this part to make space for GPS/AHRS pins)
Third layer holds the GPS/AHRS. (Sept 15 Increased thickness of this part to fit the GPS)
Added a version of the top case with recessed holes for the M3 bolts that hold it together.
I highly recommend anyone who is not limited to a 6" print bed to make the long version of this case. http://www.thingiverse.com/thing:1016829 It works much better with SMA antennas as the MCX-SMA pigtails are attached to the case.
Three part case for the Open source Stratux ADS-B receiver for people with small 3d printers.
Supports dual RTL-SDR receivers. Remove the cases and use a small amount of hot glue to secure them to the middle layer. (Nov 6 increase thickness of this part to make space for GPS/AHRS pins)
Third layer holds the GPS/AHRS. (Sept 15 Increased thickness of this part to fit the GPS)
Added a version of the top case with recessed holes for the M3 bolts that hold it together.