Thingiverse
Stocking Holder for Mantle by Jeffeb3
by Thingiverse
Last crawled date: 4 years, 2 months ago
Not terribly decorative, but it does the trick of holding a stocking over the mantle without damaging the wood. It's not critical that it "pinches" the wood, it really works just by making sure the loop of the stocking is held underneath the mantle.
The gap distance is about 26mm, so if you want it to pinch, just scale the entire thing with your slicer.
To make it more decorative, someone should use red/green filament, and change it a few times in the print (maybe like green on the outside, and red on the inside? That would look good, I think).
The gap distance is about 26mm, so if you want it to pinch, just scale the entire thing with your slicer.
To make it more decorative, someone should use red/green filament, and change it a few times in the print (maybe like green on the outside, and red on the inside? That would look good, I think).