Thingiverse
Steampunk Purse, v2.0 - Now With More Greebles! by Reversepivot1
by Thingiverse
Last crawled date: 4 years, 1 month ago
This is the updated version of my original steampunk purse. I added some extra greebles (greeblies?), and added two 5mm holes, for LEDs. There are two cups on the inside, to hold CR2032 button cells. The one I printed, I hadn't thought of that part yet, so I printed out a separate two cell holder, and just taped the wires to the inside of the body. There is also now a hole on each side, at the strap loops (the things that look like resistors on the sides), to thread EL wire through. I'm planning to sew the EL wire to a the strap, and just keep the inverter in the purse. The 10ft wires I've got should make three runs, and have a comfortable strap length.
There are holes for REALLY small magnets in the gear that spans the lid and body - I sized them for magnets that I salvaged from a laptop hard drive, but you can probably find the same size easily enough online.
I also added a flat area to the bottom, so that it can stand up if you set it down, and I flattened the inside of the top, to allow the printer to use bridging, instead of successively worse layers of overhangs. I printed with supports, because I didn't want to reprint if something failed, but they might not be necessary.
I'd love to see what it looks like if someone else makes one!
There are holes for REALLY small magnets in the gear that spans the lid and body - I sized them for magnets that I salvaged from a laptop hard drive, but you can probably find the same size easily enough online.
I also added a flat area to the bottom, so that it can stand up if you set it down, and I flattened the inside of the top, to allow the printer to use bridging, instead of successively worse layers of overhangs. I printed with supports, because I didn't want to reprint if something failed, but they might not be necessary.
I'd love to see what it looks like if someone else makes one!