Thingiverse
ST-link MB867A debug interface - STM8 Discovery - chassis by palindrom
by Thingiverse
Last crawled date: 5 years, 6 months ago
STM8 Discovery kit comes as a MCU development board with MB867A ST-link interface as a single PCB, that breaks into two.
This is a simple, 2- part compact chassis to accommodate ST-link interface, which can be used with wide variety of ST microcontrollers.
Please note that this chassis is very compact, which means it's a tight fit.
Dial in optimal settings and scale model according to your material shrinkage.
Top and bottom parts are designed with zero clearance.
PCB and component fit have 0.2-0.3 clearance, which is virtually none.
PCB must be hand sanded on ~100 grit sand paper (all edges except the one with USB port). You can sand it a bit until it fits chassis.
Have 100 and 600 sandpaper, flush cut pliers, acetone and transparent filament around.
This is a simple, 2- part compact chassis to accommodate ST-link interface, which can be used with wide variety of ST microcontrollers.
Please note that this chassis is very compact, which means it's a tight fit.
Dial in optimal settings and scale model according to your material shrinkage.
Top and bottom parts are designed with zero clearance.
PCB and component fit have 0.2-0.3 clearance, which is virtually none.
PCB must be hand sanded on ~100 grit sand paper (all edges except the one with USB port). You can sand it a bit until it fits chassis.
Have 100 and 600 sandpaper, flush cut pliers, acetone and transparent filament around.