Thingiverse
SQ12 mount - around 30 degree tilt by Katostrofik
by Thingiverse
Last crawled date: 4 years, 7 months ago
Remixed this to have a usable (for me) tilt of around 30 degrees. The other mounts were just too much. It also has a flat bottom now.
I printed with TPU and do get some jello after zip-tying it to my frame's top plate, but it's so much better than my goggles' DVR.
Should be fine without supports if printed in it's current position on its side. But by all means, use supports if you think it necessary.
In the photo with the SQ12 - I have stripped down the weight as much as possible by removing the front IR lights, the weight, and the battery - then installed the power lead to run it off 5v from the FC/PDB.
I printed with TPU and do get some jello after zip-tying it to my frame's top plate, but it's so much better than my goggles' DVR.
Should be fine without supports if printed in it's current position on its side. But by all means, use supports if you think it necessary.
In the photo with the SQ12 - I have stripped down the weight as much as possible by removing the front IR lights, the weight, and the battery - then installed the power lead to run it off 5v from the FC/PDB.