Thingiverse
Sputnik SP99 props guard by Billyben
by Thingiverse
Last crawled date: 4 years, 3 months ago
SP 99 prop guard.
About 18/19g all 4 guards. (my printer couldn't print <1mm wall, it has made them at 1,12/1,26 mm thick)
There is 4 files : 2 for front guards and 2 for rear guards. They are différent and there is no mark to différenciate them for the moment.
WIP!!
They are a little bit too high and I could make them about 1/2 mm less large i suppose. It needs some real life test aka outside.
Tested : Quite weak in PLA very noisy but functionnal.
Tested : Nylon print : enought resistant for casual crash! but 2 gramms more....
V2 : not yet tested, reinforcement of the arms, test of honey hole!
About 18/19g all 4 guards. (my printer couldn't print <1mm wall, it has made them at 1,12/1,26 mm thick)
There is 4 files : 2 for front guards and 2 for rear guards. They are différent and there is no mark to différenciate them for the moment.
WIP!!
They are a little bit too high and I could make them about 1/2 mm less large i suppose. It needs some real life test aka outside.
Tested : Quite weak in PLA very noisy but functionnal.
Tested : Nylon print : enought resistant for casual crash! but 2 gramms more....
V2 : not yet tested, reinforcement of the arms, test of honey hole!