Thingiverse
Spring Thunder Quad Loading Shell Caddy by Mrheathpants
by Thingiverse
Last crawled date: 4 years, 8 months ago
This is a quad (and twin) loading shell holder for the Spring Thunder by GDop26. It's designed to fit on molle, and allows you to twin load two shells at a time, reducing reloading speed, but also giving a solid platform to carry a lot of shells.
I'm not sure about printer compatibility, but it should be easy enough to print on a prusa sized printer.
There is also a good chance that these will go up on GDop's shop on etsy, so if you can't print them you can still buy them.https://www.thingiverse.com/thing:2846629/#fileshttps://www.etsy.com/shop/ShellEjectingBlaster?ref=seller-platform-mcnav
Updated (at the very least) the quad holders. There's just one set now and they should hold the shells snug, but not too tight when printed for strength. There are very small nubs that should ensure that it's held tight, but still removable. Simplified the whole thing, so you just print two copies of the one shell holder.
I'm not sure about printer compatibility, but it should be easy enough to print on a prusa sized printer.
There is also a good chance that these will go up on GDop's shop on etsy, so if you can't print them you can still buy them.https://www.thingiverse.com/thing:2846629/#fileshttps://www.etsy.com/shop/ShellEjectingBlaster?ref=seller-platform-mcnav
Updated (at the very least) the quad holders. There's just one set now and they should hold the shells snug, but not too tight when printed for strength. There are very small nubs that should ensure that it's held tight, but still removable. Simplified the whole thing, so you just print two copies of the one shell holder.