Spray can holder push-pin adjustable mount and union by tednv

Last crawled date: 3 years ago

My son kept messing with all my spray cans so I saw this and said, hey, this is great! I'll print like 8 of them. And I did, and then I looked at the remixes
So I didn't want to drive huge screws into my wall (they have to be huge if the cap is going to be big enough to hold the half-hole mount) and I didn't want to drive even more huge screws into my wall if I wanted to adjust the width of the brackets
So the solution? Push-pins and a slide rail! And if you're even more ocd than me, a union so each can can have it's own custom width, and even a slide rail for the bottom if you don't want any wobble or if you want to make it earthquake proof. Two push-pins are more than enough to hold the weight of a bunch of cans. If you have big cans, just slide the brackets further apart or closer together for little ones. No need to destroy your wall/door/cabinet/whatever else you're hanging these on
Just to clarify, you only need the top piece along with 2 push pins or nails if you don't think push pins will do for whatever reason. The other two pieces are only there if your obsession with perfection drives you further
Also, if you haven't printed a bunch of these already, attached is a version of the bracket without the side tabs since they're not needed with this mount