Thingiverse
Sport Cub Wing Bracket Jig
by Thingiverse
Last crawled date: 5 years, 9 months ago
This is a jig to assist in repairing the wing cover bracket of a ParkZone Sport Cub radio control airplane. It holds the posts in perfect alignment so you can press or clamp until the glue dries. I used 5 minute epoxy forced into the cracks with a T-pin.
Before printing, verify that hole centers form a rectangle 49.5 x 164 mm.
Print 2 jigs and connect with 5 mm diameter chopstick stock cut to 174 mm length. You could use my chopstick cutting jig and a razor saw to make precise cuts. You can glue in the chopsticks, but that's not necessary. The jig takes up less space in storage when disassembled.
Applies to these planes:
ParkZone Sport Cub 1.3M (discontinued)
HobbyZone Carbon Cub S+ 1.3M
Before printing, verify that hole centers form a rectangle 49.5 x 164 mm.
Print 2 jigs and connect with 5 mm diameter chopstick stock cut to 174 mm length. You could use my chopstick cutting jig and a razor saw to make precise cuts. You can glue in the chopsticks, but that's not necessary. The jig takes up less space in storage when disassembled.
Applies to these planes:
ParkZone Sport Cub 1.3M (discontinued)
HobbyZone Carbon Cub S+ 1.3M