Spoolholder for Primacreator P120 (will most likely fit other rebrands of this printer)

Last crawled date: 4 years, 2 months ago

This spoolholder is inspired by the one designed by "Toys", it's not a direct remix, but I took much inspiration from his design. The differences is that my design is beefier and will easily support a 1kg spool over time, it's held together by a notch rather than a pin and I also angled the "arms" to lift the spool closer to the extruder to get a more horizontal angle on the filament. I also added a roller and "hubs" for the spool so it'll roll with very little friction to ensure smooth feeding.
it can probably be printed without supports, but I recommend using light support to stabilize it during printing. I printed it with 0.3mm layer height, but you can go lower if you want a smoother finish. The installation should be quite self-explanatory, slide on part 1 first, then part 2 slides on to part 1 and it all "clicks" in place. You may need to sand the notch a bit depending on how precicsely you're able to print it.