Thingiverse
Spool Spacer for FlashForge Creator 3 by ThomasWilko
by Thingiverse
Last crawled date: 4 years, 11 months ago
A ~10mm spacer that I made to raise a slightly oversized spool that was rubbing on the lower surface of the Creator 3's stock side spool holder compartment.
Can be scaled in the vertical axes in FlashPrint to make the spool sit higher or lower if so desired, although this isn't recommended.
Included is a SolidWorks part if you were wanting to modify it.
Can be scaled in the vertical axes in FlashPrint to make the spool sit higher or lower if so desired, although this isn't recommended.
Included is a SolidWorks part if you were wanting to modify it.