Thingiverse
Spool Holder PrintaLot by juan15pablo
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a totaly printed spool holder.
It was printed with a CEL Robox.
The X were printed with 0.3mm layer tickness, and the rest with 0.2.
It take about 2 hours each X, and 2 hours the semicylinder with the brackets.
The only who need support is the semicylinder.
It was desing for PrintaLot spool (25mm inner diameter and 200mm total spool diameter).
It was printed with a CEL Robox.
The X were printed with 0.3mm layer tickness, and the rest with 0.2.
It take about 2 hours each X, and 2 hours the semicylinder with the brackets.
The only who need support is the semicylinder.
It was desing for PrintaLot spool (25mm inner diameter and 200mm total spool diameter).