Spitrit Halloween Proton Pack 1/4" hose adapter by Fer451

Last crawled date: 3 years ago

I noticed the red tubing on the bottom of the pack was too small, and that the blue tube was missing.
The piece that holds on the red tube has 2 screws that let you remove half of it. I designed a pice that screws on itn its place and lets you used 1/4" tubes. It isn't perfect, but it turned out fine with some fine tuning.
It isn't screen accurate since the tubes on the underside of the original run into something that looks more like a box. But.... it is better that it was.
It's tricky to get it on, I had to ream out the holes a bit. I printed at 0.06mm layers so I didn't have to sand it.
I would think that printing with supports for the 2mm screw gap on the underside would have solved this. But I have one and it works.