Spherical Bath Bomb Mold + Bonus Tool! by crizzle 3d model
3dmdb logo
Thingiverse
Spherical Bath Bomb Mold + Bonus Tool! by crizzle

Spherical Bath Bomb Mold + Bonus Tool! by crizzle

by Thingiverse
Last crawled date: 3 years, 1 month ago
Spherical Bath Bomb Mold + Bonus Tool!
Make a standard bath bomb with some crystals or other special ingredient embedded inside it by using this clever mold kit!
Print the sphere out twice (with the large part facing down).
Print the end caps out twice (with the flat part facing down).
Print the central cylinder out twice (with the flat part facing down).
Print the cylinder ends out twice (with the flat part facing down).
Super glue the cylinder ends onto the cylinders.
You can use two cylinders, one cylinder or no cylinders!
Push the cylinder through one half (or two halves) of the sphere(s). Pack your bath bomb mix into the remaining areas and push the two halves together (while twisting). Pull out the two cylinders with a twisting action (which leaves a hole all the way through if using two).
Put an end cap on one end, add a little bit of bomb mix in (perhaps about 5-10mm worth), then add your special ingredient (crystals or anything else suitable) until they are about 5-10mm from the top. Add more bath bomb mix and pack in before adding on the other end cap. You want the two ends packed in real tight.
Leave it 5 mins then take the each mold half off. You can take each cap off and push the mixture to help the mold separate from the bomb. Don't leave the bombs in the molds whilst drying or they will be stuck.
Scale the models up and down to suit you size needs!

Tags