Special washers for Dunlop(R) Straplok(R) (for thin straps) by Frickelpiet

Last crawled date: 4 years, 7 months ago

This are two washers for the Dunlop(R) Straplok(R). They clamp especially thin straps much tighter than the original washers. Just print them out and slip the locking pin through the 3d-printed recessed washer. Then insert the locking pin through the hole in the strap and slip the 3d-printed flat washer over the locking pin. Finally snap the retainer clip into the locking pin's shank groove.