Thingiverse
SPARC HEPA Face Mask by ehalverson
by Thingiverse
Last crawled date: 5 years, 8 months ago
I DID NOT DESIGN THIS! Please see designer's info below and if you'd like to donate they have a link on their site.
https://sparc.industries/pages/3d-printable-hepa-face-mask
I just saved their 3 STL files into 1 and fixed the scaling (original files were in inches)
You can print everything together using SPARC_HEPA_Face_Mask.stl
OR
You can print: 1x M_MASK.stl
2x FILTER_CAP.stl
2x M_MASK.stl
You'll also need:
Filter Paper Element (HEPA or MERV 13 Rated)
Single-sided Foam Tape
Elastic Cord
I have not printed this yet either, I'm hoping to have time to print a few this weekend.
So far it looks like it should print well with the conical supports touching buildplate in Cura if you leave everything positioned as is in the single file. I have the main mask positioned this way because I was trying to minimize rough surface areas left by supports to make it easier to disinfect.
Keep in mind that if a mask protected you from the virus, it's carrying the virus. Disinfect surfaces and replace filters regularly.
https://sparc.industries/pages/3d-printable-hepa-face-mask
I just saved their 3 STL files into 1 and fixed the scaling (original files were in inches)
You can print everything together using SPARC_HEPA_Face_Mask.stl
OR
You can print: 1x M_MASK.stl
2x FILTER_CAP.stl
2x M_MASK.stl
You'll also need:
Filter Paper Element (HEPA or MERV 13 Rated)
Single-sided Foam Tape
Elastic Cord
I have not printed this yet either, I'm hoping to have time to print a few this weekend.
So far it looks like it should print well with the conical supports touching buildplate in Cura if you leave everything positioned as is in the single file. I have the main mask positioned this way because I was trying to minimize rough surface areas left by supports to make it easier to disinfect.
Keep in mind that if a mask protected you from the virus, it's carrying the virus. Disinfect surfaces and replace filters regularly.