Thingiverse
Snapmaker A350 Filament guide by sdj544
by Thingiverse
Last crawled date: 4 years, 6 months ago
Filament guide for Snapmaker A350
I was able to keep my filament roll inside the the enclosure by just lowering it a few screw holes.
The only problem I've found with this is that the filament will sometimes wrap around the z-tower (especially after going to home position) This keeps it from doing that.
I printed this in PETG but PLA should work just fine.
Not sure if it would work on an A250. Let me know if it does.
I was able to keep my filament roll inside the the enclosure by just lowering it a few screw holes.
The only problem I've found with this is that the filament will sometimes wrap around the z-tower (especially after going to home position) This keeps it from doing that.
I printed this in PETG but PLA should work just fine.
Not sure if it would work on an A250. Let me know if it does.