Thingiverse
Snap-together clamshell housing for openSip+Puff by jasonwebb
by Thingiverse
Last crawled date: 4 years, 3 months ago
This is a snap-together chamshell housing for an open-source sip-and-puff interface I'm working on called openSip+Puff.
The housing is comprised of two halves that fit together using mating ledges that are offset by about 0.2mm.
It was created in OpenSCAD and is fully parametric, so if you need to adjust the fit (or anything else for that matter) just grab the .scad file and have at it!
The OpenSCAD script relies on the following libraries from MCAD:
boxes.scad
units.scad
nuts_and_bolts.scad
Read more about the development process for this housing on my blog at: http://jason-webb.info/2013/05/snap-together-3d-printable-clamshell-housing-for-opensippuff/
Video: http://www.youtube.com/watch?v=rA8_EXlYiVA
The housing is comprised of two halves that fit together using mating ledges that are offset by about 0.2mm.
It was created in OpenSCAD and is fully parametric, so if you need to adjust the fit (or anything else for that matter) just grab the .scad file and have at it!
The OpenSCAD script relies on the following libraries from MCAD:
boxes.scad
units.scad
nuts_and_bolts.scad
Read more about the development process for this housing on my blog at: http://jason-webb.info/2013/05/snap-together-3d-printable-clamshell-housing-for-opensippuff/
Video: http://www.youtube.com/watch?v=rA8_EXlYiVA