Thingiverse
Snap-off anti warping pads REVISED by chrismolloy
by Thingiverse
Last crawled date: 4 years, 7 months ago
Updated to include 4 1mm thick pads. Seem to work just as well, taking less time to print.
Here are some pads I designed for reducing warping. They are designed to snap off after printing. Note, the pad is designed to fit on a square corner, which is where most warping happens. Simply position the pad at the corners of your part, print and snap them off. A little sanding will neaten things up after removal. I have found them to work very well, as seen in the before and after photos.
Comments are welcome.
Here are some pads I designed for reducing warping. They are designed to snap off after printing. Note, the pad is designed to fit on a square corner, which is where most warping happens. Simply position the pad at the corners of your part, print and snap them off. A little sanding will neaten things up after removal. I have found them to work very well, as seen in the before and after photos.
Comments are welcome.