Sn42 / Sn3.5 QR ALY Wagon

Last crawled date: 4 years, 4 months ago

For:
1:64, S Scale on HO / 16.5mm track.
What it is:
A low detail 4 wheel wagon (Not up to the quality of a modern ready to run models, this is a kit!)
Additional Parts Needed:
4 x 2mm "Top Hat" Bearings - 00 Gauge Romford Pin-Point Brass Bearings, Shouldered Type DW22 (Got my last lot from https://dundasmodels.co.uk/)
2mm Drill to gently clean out the axle holes
Hornby 12.6mm wheels spokes or solid disc
0.5mm brass wire
Couplers of choice (Hook, Kadee or Sprat & Winkle)
Gap Filling Super Glue (Zap a Gap)
Notes:
Print 1 sets of side walls
Print 1 sets of end walls
The end walls go on the inside
Print the floor and side frames with support
Lightly sand glue contact surfaces
Gently drill out 2mm holes in side frames before fitting ROMFORD bearings
The final product will depend on the quality of the printer and how you have your settings under control
Supplied as is, no support and no promises
I recommend using a 0.3mm Nozzle for better detail and 0.1 or 0.08mm layering