Thingiverse
Smooth Fang Mounting Plate - Ender 5 Plus - Micro Swiss Direct Drive - BLTouch - ExoSlide by Frybr
by Thingiverse
Last crawled date: 4 years, 2 months ago
Smooth Fang Mounting Plate - Ender 5 Plus - Micro Swiss Direct Drive - BLTouch - ExoSlide
BLTouch Approximate Offsets = X-44.6, Y-6.6
Ender 5 Plus (with BLTouch probe), using a Micro Swiss Direct Drive extruder kit, mounted to an ExoSlide linear slide kit.
I encorporated an integral cable support, and tried to relieve the corner to allow people without an Exoslide to use the stock belt slots.
Also included an X-gantry cable support.
M3 fasteners throughout. BLTouch is a close-fit (see photographs), but I wanted to keep it tight.
I also model the holes with tight tolerances, so you can ream them to 3mm if you want.
My first designs while teaching myself Fusion 360. Hope this helps someone out.
40mm Fan Duct
Filename: FANG-oz-40mm-MicroSwiss.STL
"This thing was created by Thingiverse user ozfunghi, and is licensed under cc-nc-sa."
CR-10 FANG OEM fan duct assembly - easy & sturdy print by ozfunghi on Thingiverse: https://www.thingiverse.com/thing:2763931
Smooth Fang Duct (using 5015 Blower Fan - 24V)
Filename: MicroSwiss_Direct_Drive_Smooth_Fang.STL
"This thing was created by Thingiverse user amass3d, and is licensed under cc."
Micro Swiss Direct Drive for CR10/10S/Ender3 - Smooth Fang Setup by amass3d on Thingiverse: https://www.thingiverse.com/thing:4389912
BLTouch Approximate Offsets = X-44.6, Y-6.6
Ender 5 Plus (with BLTouch probe), using a Micro Swiss Direct Drive extruder kit, mounted to an ExoSlide linear slide kit.
I encorporated an integral cable support, and tried to relieve the corner to allow people without an Exoslide to use the stock belt slots.
Also included an X-gantry cable support.
M3 fasteners throughout. BLTouch is a close-fit (see photographs), but I wanted to keep it tight.
I also model the holes with tight tolerances, so you can ream them to 3mm if you want.
My first designs while teaching myself Fusion 360. Hope this helps someone out.
40mm Fan Duct
Filename: FANG-oz-40mm-MicroSwiss.STL
"This thing was created by Thingiverse user ozfunghi, and is licensed under cc-nc-sa."
CR-10 FANG OEM fan duct assembly - easy & sturdy print by ozfunghi on Thingiverse: https://www.thingiverse.com/thing:2763931
Smooth Fang Duct (using 5015 Blower Fan - 24V)
Filename: MicroSwiss_Direct_Drive_Smooth_Fang.STL
"This thing was created by Thingiverse user amass3d, and is licensed under cc."
Micro Swiss Direct Drive for CR10/10S/Ender3 - Smooth Fang Setup by amass3d on Thingiverse: https://www.thingiverse.com/thing:4389912